JLJ wrote:
Even if you do a single layer layout, then, the layer "Component" can
be considered as a manual layer you will use to put some strip wire
(so, I mean, nornal wire, but not copper on the pcb).
So, it's better you stay with 2 layers routing in any case.
That makes sense. However, on a single layer PCB you normally wish to minimise the number of links. Is there some way to get the autorouter to do this i.e. route as many tracks as possible on the copper side and as few as possible on the component side? At the moment I force the autorouter to route only on the copper side by selecting both layers as copper in the 'Select Layer Pair' dialog.
Ian
--
Ian T-Bell
aka RuffRecords
aka RedTommo
www.geocities.com/ruffrecords
