Bob,
one can have that box unclicked.
Thus the command wouldn't point to any particular VFO,
please...
Best regards,
Alec
------ Wiadomo?? oryginalna ------
Data 08.04.2025 18:15:05
Temat Re: [hamlogger] Slave port: Kenwood commands to control an amplifier
I could remove the FR0; but I have no idea how that will impact other users of the slave port with different devices connected (for example another Kenwood radio). SeventyThree(s).
On 04/08/2025 12:03 PM EDT Alec SP2EWQ via groups.io <aleksander.otulak@...> wrote:
?
?
?
?
Bob,
?
please,
any chance to rectify that?
?
Please...
Best regards,
Alec
?
?
------ Wiadomo?? oryginalna ------
Data 08.04.2025 17:58:17
Temat Re: [hamlogger] Slave port: Kenwood commands to control an amplifier
?
The problem is possibly/probably caused by Logger32 sending a FR0; command to select VFO-A before the FA xxx; frequency command. SeventyThree(s).
On 04/08/2025 10:53 AM EDT Alec SP2EWQ via groups.io <aleksander.otulak@...> wrote:
?
?
?
Hi,
?
I have been trying, still unsuccessfully, to make my amplifier follow TRX band changes
using Loggr32's Slave Port and Kenwood commands.
?
My slave port configuration
?
Slave debug window shows the following commands upon band changes
to which the amp stays unresponsive
?
?
However,
using a Kenwood command simulator to which the amplifier responds correctly,?
I can see the following communication on the port?where, in the box,?
You can find the moment when the amp switched from 10m to 15m band)
?
Will You help,
please?
?
Best regards,
Alec
?
?
?
?
?
?
