开云体育

Hi All, I've appreciated all the info that I've gotten on the Kenwood TL-922A and I've ordered the relay switching board from Harbach.? While I'm in there, I'd like to address the filament voltage.?

FYI: " WARNING: *Never mix ammonia with bleach*. This causes the release of toxic chlorine gas, which can be deadly." Read ingredients of the products you are mixing.? If they have the above in any

It’s not worth the effort to eliminate the nicotine covering on any radio, despite the radio’s value. Your life is worth more. If you can return it if bought, do so. If not trash it. I’ve done

Good safety info reminders, thank you. Meanwhile here is #2 bread slicer, before and after. Soon as it was immersed, there was a tar film that appeared in the surface near the bubbles, it almost

I know of MEK, its very brutal...a rag with some on it will strip paint immediately off metal with only one wipe. I dont think its wise to be using that in our trade, way too powerful. -- Steve Hearns

"Scrubbing Bubbles" will remove nicotine from metal and paint. Don W4DNR

In a recent Shure fatboy rebuild from 1941 and 1943 the re-plating of the zinc frames were called for, but it was up to me first to get rid of years of nicotine build-up from chain-smoking radio

That type of thing happens when you inadvertently mix an ammonia based cleaner with a chlorine based cleaner.You get the same kind of gas that was used on? troops during WW 1.? Ain't good.? Even

This is an important caution below from Kim. I did mix cleaners together for a difficult cleaning. It hurt my lungs and put me in bed for a day. I did recover. I realized I was being poisoned before

Just a caution here.? Be VERY careful about what you mix together.? It's very easy to poison yourself from a BAD reaction of the chemicals.? Just a heads up for others.? Personally I've always

Latest photo of the chassis as I am removing and cleaning each individual assembly. Just took the top bread slicer out and I have a seperate plastic container I will fill with the Fan-monia and let it

Thanks for sending twice. Sent: 12 December, 2024 9:03 PM To: [email protected] Subject: Re: [ham-amplifiers] HV Wire

Thanks for the heads up, Alan Sent: 12 December, 2024 9:03 PM To: [email protected] Subject: Re: [ham-amplifiers] HV Wire

Mcmaster carrs prices are absurd....and are? per foot !! I used rolls of belden 10 kv test prod wire.? It comes in red or black.? 18 ga stranded...and silicone rubber...and flexible as spaghetti.?

On Sun, Nov 24, 2024 at 01:10 PM, Walter wrote: > >

McMaster-Carr sells high-quality HV wire, in several sizes and volt-ratings: HERE: https://www.mcmaster.com/products/high-voltage-wire/ -- 73, ~Alan

Good quality coax. With SHV connectors.

Akek, That worked! Thanx. My Kenwood has a soft start in it already (Kessler). My Henry (2K-3) about once every three months will trip the breaker when turned on. I can live with that I guess. The amp

Hi Bob Search for 100A 4000W High-Power Soft Start Circuit Power Board for Class A Amplifier Amp 73, Alek.

In the soft start device I'm talking about, it gets switched out of circuit by the 100A relay, just like the resistor in a normal slow start. Alek VK6APK