I? made a serious? error? when plugging numbers into the
PSUD-2? ?power supply software.? Like an idiot,? I used
the? wrong? plate xfmr? ?DC? primary?
resistance.? I was plugging in? ".1 ohm"..... when it shoulda
been? ",01 ohm" .? ? ?Well that? makes a
helluva? difference? to the calculated? ?source?
Z? of the? plate? xfmr.??
I did have the? secondary? ?DC? resistance correct
though? ( 4.5 ohms? across the 3900? tap....and? 6 ohms
across the? 5200? tap).?
On the 3900 tap, source? Z? is actually? just 7.411?
ohms.....? and? NOT? ?33.61? ohms.?
??
On the? 5200? tap,? source Z? ?is actually just
11.61? ohms.... and NOT? ? 57.6? ohms.?
B+? ?V drops? under a steady...or? varying load are
of course? much improved.? ?Hardly any drop at all.?
The resonant choke? setup is still? a dud? though.?
?It's? a glorified? 120 hz? notch? filter...and let's
all the? harmonics? pass on through.? ??
Too? easy to make? errors.?
Jim? VERF?
