Bill,
To connect to this connector you need a mating connector made for attaching wires. I strongly recommend you do not solder to the connector pins. Just makes a mess.
This looks similar to a MOLEX 2.50mm SPOX type connector. However, the connector pins are probably on .156 or .39mm centers.
If you go to either www.mouser.com or www.digikey.com you can browse their connectors trying to find a mate. If there is a manufactures label on the connector it would be a good start.
73, ron, n9ee/r
toggle quoted message
Show quoted text
--- In Electronics_101@..., "worktoil" <worktoil@...> wrote:
I'm trying to determine the best way to hook up to the connector shown in the Photos section under Miscellaneous/unknown.connector.jpg.
It is a stepper motor driver board. I have searched the internet by the board's id and found nothing. I can not find any product ids on the connector itself.
Any suggestions?
Thanks
Bill
