--- Stefan Trethan <stefan_trethan@...> wrote:
How did you manage that?
In a nutshell - cheap breadboard. I was fumbling
around trying to put a wire in place. In doing so I
pushed one side of a resistor down to where half of
the lead was now "in" the board. Apparently, the lead
was pushed far enough in so that it was sticking off
the "pad" benith it and making contact with the row
right above it. It wasn't a serious problem, it was
just a pull-up for an I2C bus, but it sure did take a
little while to figure out why the clock and data
lines were always in synch.
Shawn
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
