Ok, I'm trying out on here.? I haven't been getting anything from here so I want to see if this goes out in email.
New trike project.? ?This one will get a 500w 24v scooter motor on it.? The pedals with drive the right rear wheel and the motor will drive the left rear wheel.??
It's only a single speed at the moment. I'm not sure if I want more speeds on it yet.
I refused to pay $80 for a new rear axle that it needed and decided to go? instead with a 5/8" zinc plated shaft from home depo for $8 or so. I had to also replace the rear bearings as the original
shaft was a 15mm type.? Since I needed two axles anyway that?worked out just fine as it was three feet long. I just cut it in half and am using one for each rear wheel.
I haven't figured out exactly what I'm going to do for rear brakes yet.? Possibly get some axle adapter and use disk brakes between the frame and rear wheels.
Lee Bell