I still question why the banjo is not an option
Richard
toggle quoted message
Show quoted text
On 02/02/2020 17:05, John Dammeyer wrote:
Hi Charlie,
Nice job on yours.
Ralph's initial problem is finding a vertical surface on which to
mount the motor that allow the motor shaft to be perfectly in line
with the lead screw.Hence the suggestion for belt drive which could be
1:1 and then alignment isn't as hard.
John
*From:*[email protected] [mailto:[email protected]]
*On Behalf Of *CLevinski
*Sent:* February-02-20 6:58 AM
*To:* [email protected]
*Subject:* Re: [digitalhobbyist] Suggestions for mounting stepper Z #MODS
Ralph,
Of course, it all depends upon how much torque you need, but I
direct-mounted mine on my 7 x 14 mini-lathe.
--
Regards,
Charlie
New Jersey, USA
/*LAW OF ANNOYANCE: When working on a project, if you put away a tool
that you¡¯re certain you¡¯re finished with, you will need it instantly.*/
