Re: #MODS Lathe motor upgrade #MODS
|
Lol. I made a smaller, simpler bracket for mine.
This lathe has about a quarter the swing of your Atlas so I don¡¯t need a countershaft to not run the plain bearings too fast. ?
There was some stuff about interfacing with the controllers on the Taigtools Yahoo group - I don¡¯t know what got transferred here to groups.io or if there¡¯s a more general source. What little I did in that area was kind of kludgy but I don¡¯t think it was much more complicated than with brush dc treadmill controllers.
?
On Wed, Jan 1, 2020 at 01:50 PM, Ralph Hulslander wrote:
I have a 101.07403 12x36 Craftsman Lathe with a 1/2hp motor. |