I have seen some people used electric drills, so I am confused on how big of a motor is needed.
It would not take a big motor to move the table, except for Z that might take a bigger motor.
But it would take more power when making a cut.?
I suppose I will just have to try various motors to see what works, I'll integrate a amp meter into the controls
to make comparisons.?
Now I Just need some snow on the ground so that I can get into my shop.
Thanks again everyone.
Ralph
?
On Wed, Aug 21, 2019 at 5:36 PM Ralph Hulslander via Groups.Io <rhulslander=
[email protected]> wrote:
Thanks that is why I asked! I do not want to turn dials. I do not need CNC, well at this point I do not need CNC.
I just want motorized X, Y and Z.
The
I have outfitted DRO on all of the axis? and installed a .
Ralph
On Wed, Aug 21, 2019 at 4:00 PM Richard <
edelec@...> wrote:
Those are for the X axis feed on a mill. IMHO far too big for the
Clausing 8520.
What do you want them for? You said X Y Z which indicates CNC. If so
these are totally wrong, as are the geared motors you discussed.
Richard
On 21/08/2019 19:58, Ralph Hulslander wrote:
> Should I use these type of motors
> <>
> for my Clausing X, Y and Z? Or should I just hacktogether some other
> odd motors? I do have some Gear Reduced Brusless DC motors top speed
> 18 rpm, also I do have one Brushless DC GR motor that came off a
> garage door opener I can't remeber the RPM.
>
> Any ways these motors
> <>
> are designed for a Bridgeport Mill so I would have to make some
> modifications, not sure why they would not work for Y and Z but are
> listed as for X.
>
> I hope this post is within the scope of the forum.
>
> Ralph
> --
> Clausing 8520, Craftsman 12x36 Lathe, 4x12 mini lathe, 14" Delta drill
> press, 40 watt laser, Consew brushless DC motors and a non working 3D
> printer
>
--
Clausing 8520, Craftsman 12x36 Lathe, 4x12 mini lathe, 14" Delta drill press, 40 watt laser, Consew brushless DC motors and a non working 3D printer
--
Clausing 8520, Craftsman 12x36 Lathe, 4x12 mini lathe, 14" Delta drill press, 40 watt laser, Consew brushless DC motors and a non working 3D printer
