¿ªÔÆÌåÓýJust a quick update on this. I have a BBS (Synchronet) running enough that I can dial-in from another PC and connect properly. I started with the Hayesmodem 300, which was painful, and then changed to the Hayes Optima 144 which was respectable for dial-up. ? Using the Z80MC, I can get the modem to go off-hook, dial, and connect but it¡¯s not sending/receiving. I use this same modem with HyperTerm to dial the BBS, so it¡¯s not the modem or cable. I¡¯m thinking it¡¯s related to handshaking so I need to look at the init string.?I might also try the following: switch to 32K SRAM and lift the RTS/CTS pins on the 8250 and bring them out to the level shifter DE9 that I have and see if that makes a difference ¨C it would provide full handshaking. ? Even with that, overall, good progress in getting it going. More to come once I get the 32K SRAM next week. ? Rich ? -- Rich Cini ? ? On 8/18/20, 10:10 AM, "Richard Cini" <rich.cini@...> wrote:
? Good point. I think I have a 512K one because that¡¯s what I had handy ¨C they¡¯re used in many of the Retrobrew ECB and John Monahan¡¯s S100 various boards. I don¡¯t think I have any 62256 chips around, but so long as I keep handshaking disabled, we should be good. ? I will give a revised ROM a try. It¡¯s just an extra set of steps to use, but might be a fair compromise given the very narrow use for this. ? I requested a full data sheet on the modem from the manufacturer. It uses the AT command set which is good, but it has a reset pin, so I¡¯m looking for the required pulse width for it. RESET isn¡¯t exposed on the Z80MC when it¡¯s in a case ¨C P1 on the SIO has a missing ¡°key¡± pin with no hole. So, I plan on a simple RC circuit local to the modem (if needed). ? I found a text-based browser called ¡°Links¡± which is like Lynx but it seems to be pure text with no DOS-graphic characters. It¡¯s written in C, so maybe there¡¯s a way to pare it down to a bare minimum just to parse basic HTML. Need to look at that. ? More to come! ? Rich ? -- Rich Cini ? _._,_._,_ |
