开云体育

<https://www.ebay.co.uk/itm/192873045696?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=7qaf0C6WSW-&sssrc=4429486&ssuid=NfzeolfuRXq&var=&widget_ver=artemis&media=COPY> [s-l400.jpg] FTDI USB Cat cable

Hello dr om, I use FT847 with SUCCI interface and no problems, I connect FT847 by his cable to SUCCI interface (eBay) you must specified then it is for FT847.I use it more then 10 years with UCX Log

Hello everyone, I bought a second hand Yaesu FT847 and then I was build a isolated interface for DATA IN/OUT port. It works very well but I haven't build null modem cable for CAT control. I am not

Can someone point me to the correct mini dip plugs for the FT840 and FT847.? I am looking for them for the tuner jacks in particular.? On the FT840 one appears to be a 5 pin mini din but the center

for SSB modes you must use the 1/8" TRS data jack for audio in/out and keying the circuit is shown in the manual neither of my 847s are deaf not great? but not deaf

HI All 100% correct! I would also add that compared to the position of the minimum distance (= height at EL 90 degrees), you will have the frequency of the SATELLITE which for the IO-117, would seem

Hi Spence, the fact that you have to use different frequencies when transmitting and receiving is quite simply the Doppler principle. It also has nothing to do with linear. Of course, these two

All that I know is I am using the Data Port to the Signalink. Gary [email protected]> wrote:

Doesn't the 847 use a different output port for VHF/UHF? Micky K1XH

Anyone have noise issues with the SIGNALINK USB on MSK144 with the FT-847. My FT847 is quite deaf on 6 meter MSK144 and it seems the issue is Noise with the Signalink USB. I utilize the Data Port on

Hi Tom, I am totally confused on this matter as I have spoken to a well known source that tells me if the transponder is linear then the uplink and downlink frequencies are the same on a Digipeater

Hi Spence, I am working the GC since 6 month and I did not find a solution for that problem so long So I drive the main vfo by gpredict (via cat) and adjust the sub-vfo manually by those values

Will do ?Get BlueMail for Android ?

You can download load the manuals on this forum, have a poke about 73 Andrew G8UUG ?Get BlueMail for Android ?

Andrew, Nice to meet you and thanks for the repair tips. I do have a copy of the service manual - which I plan on reviewing prior to performing any adjustments. I'll probe the test points you refer to

Check TP1003 If this is out of lock you will only get FM! 73 Andrew Sent: 10 October 2023 18:18 To: [email protected] Subject: [YaesuFT847] FT-847 only transmitting on FM mode. de: W1SMS To the

Hi one of your LO's our out of range, check all the TP, there is one that duold be 4 V you may find it is .2. Work through the set up procedure on the AF board. 73 Andrew ?Get BlueMail for Android

To the group; My trusty FT-847 has stopped transmitting on all bands (HF>UHF) on SSB, CW and AM modes. It does work OK on the FM mode - TX audio via mic is OK. I did try swapping the TX & RX filter

Hi The scope is fine, but not what you need, ?Get BlueMail for Android ?

does Simon's (G4ELI)? sdrconsole do tracking ?