开云体育

I set the audio level to just barely cause the ALC to move when in transmit mode.? I set the power control on the radio to give me the desired watts out.? I use this same method for all of the

So for SSB modulation, the volume level is what sets the output power to a large extent. So both the power output setting on the radio and the volume setting on the computer interact. How do you

Peter, correct.? After that, I use the actual power control on the FT-847 to set my output power.

Peter, That is exactly what I do when I use my FT847 with JS8. Steve NA4SA

No! If I understand you right. You must set your radio settings how you want. This is not the same power as on the software. There is a scale you adjust this to change the audio level. I think it’s

Call????? Envoyé depuis Yahoo?Mail pour iPad

Hey all. Just playing around with FT8 and reading up as much as I can. Many links and how to's mention that you just need the ALC to flicker. SO I have set the PWR meter set to ALC. So in regards to

Hmmm found the menu and the issue. I had the baud rate different. I made up a cable as per an online link. Once I changed the baud rate all went well....

you know you need a null modem type connection correct?? which cable type are you using?

Hey all. Tinkering around with an old (but newly aquired) 847 and doing what I like best and hooking up computers etc. I dont seem to be able to get any cat software to comminicate with the radio. is

I used to use a remote rig interface on my TS480sat with great results https://www.remoterig.com/wp/?page_id=1051 or https://www.remoterig.com/wp/ The FT847 will interface but you will need remote

You should check the serial number of your 847 against the version chart (somewhere on the 'Net - I forget where). The early versions could only be driven from CAT, not read from. Not being able to

Something as simple as a USB to RS232 adapter and then dev/ttyUSB0 normally My interface of choice is rather expensive but very reliable but you can get them from the internet here in the UK second

Yaesu FT847 remote with PSTRotator youtu.be Sent while portable! please excuse typos.

Just my 2 pennies worth. Interfacing and controlling your FT847 remotely is very simple, however piping audio back and forth over the internet ….. tough….. very tough. For my satellite setup I

Hey All. I just picked up a 847 second hand (obviously) and want to use it at a remote location if at all possible. I have been scanning this group for links and suggestions for interfacing ideas etc.

This warning Jeff?

I was more concerned with the diodes they show in the Yaesu manual in the ALC cable, The cable in manual was designed to connect to 4 amps. My 847 may never see an amp inline if it does it will most

I think you will find it is the PTT you are not supposed to use with an amplifier. This is a low level, low current switch and meant for foot pedals as an input. The Standby socket however can switch

If you read your manual, you will see there is a warning not to use the ALC for an amplifier. Sent from Jeff M0UHF