开云体育

I’m not sure about the question you are asking me I have put this frequency in the title and in the message 160 m and 80 m. The error appears across the screen as if it was out of band as it would,

More information needed. Where does it show error? On what frequencies?

Hi, I have just received a ft847 and I have noticed it does not work and shows error as if it was out of band on 160m and 80m. Please can somebody advise.

I have always used an extension speaker with my 847, far bettwer quality. Leighton. GW3FSP.

I found the solution: the internal speaker is "a kind of" defect. By pluging in an external speaker, no distortions are there. Thank you all for helping me. I have another problem with that trcv but I

It does work quite well

On or off I mean Get Outlook for Android

Correct connor off Get Outlook for Android

Is the speech processor just on/off? I don't see anywhere to adjust the compression level.? Thanks

Max, Yes, I was looking at one of those Kuhne electronic QH40A Cyrstal heaters something like you have. I was worried about the trimmer also being a problem,? so thought kill 2 birds with one stone

I installed one of these on X1001 crystal https://www.ebay.com/itm/284785374391 Works quite well. Max

Thanks, that did the trick changed L 26-28 and H 33-36. Rig if on freq adjusted it on UHF with my IFR-1200S so within about 10hz. The variable not the best. Think I will put in a TCXO next.

Correct Make sure everything is on frequency first! 73 Andrew Sent: 28 September 2022 19:21 To: [email protected] Subject: Re: [YaesuFT847] Discriminator Meter Off Center I had the same problem. I

I had the same problem. I had to go into the service menu and adjust the DISC-L and DISC-H settings. Look in the files section. Max

Hello, I just got my first FT-847 a week ago. I notice the discriminator always pulls to the left even with no signal. I did adjust the ref osc as it was off freq a bit. Looks to be about 900hz off. I

Hi folks, With the return of sunspots and randomly good propagation, a short note which you might want to know about. I heard early today that propagation on 10 meters was open from the West Coast to

Well done for finding this, I wonder what killed the amps, check the 8V and 5V rails! 73 Andrew Sent: 13 September 2022 08:06 To: [email protected] Subject: Re: [YaesuFT847] No power on SSB A quick

Wonderful news! Glad you got it sorted out and kudos to your friend for helping. Micky K1XH Links: ------ [1] /g/YaesuFT847/message/653 [2] /mt/92785771/1045683 [3]

A quick update as a closure to the no SSB problem. After I got help by a friend in tracing the audio signal, we had to replace the NJM2902 op-amps. I went ahead and replace both chips. The radio is

I second the Tiny SA. I bought one recently while trying to solve my no UHF output issue. They are great little devices. I have the matching analyser and oscilloscope. While not costing nor matching