开云体育

I'm interested in a demo. Sent from my Verizon, Samsung Galaxy smartphone Get Outlook for Android<https://aka.ms/ghei36> ________________________________ Sent: Saturday, July 25, 2020 4:03:30 PM To:

Tony, Please read Keith's and my posts on the subject. This was non-warranty repair for damage that was caused by an outside voltage differential. That is outside of their purview and subsequent

What would the objective be, I wonder? Just curious. Could not use it for VUCC for most of us. Do you have the time/energy/ finances to make all work and support it? And, 6m conditions have been

Hi all I find the Elecraft response disingenuous. $200 for 2 hours, but $125 for 1 hour when this should be a warranty repair is ridiculous. My vote is to leave the KRC-2 at Elecraft and spend the

To echo Keith, I also received a call from Eric as well. We had a very productive chat. The surge was possibly caused by EMP on the relay control lines. A lightning strike? a mile away could generate

Any way to configure the equipment that when in digi mode the RF out is lowered? ---? Ciao baby, catch you on the flip side?? 73 de W3AB/GEO ??? http://www.w3ab.org You can say "over", you can

I use teamviewer as well with my home station. Ran field day 95% remote using a chromebook around my house. Home station is currently a flex 1500 into an amplifier and tuner - not completely

We would use WJST-X on our computers and only TX/RX audio via the remote, possibly VOX.? My setup at home is using the K3 and hex antenna and WSJT-X on the remote laptop then using Teamviewer to

Agreed here - all you need to do on the RCORB side is to pipe the audio to and from the remote. There are a few other tricks for rig control, etc... but it's not to difficult if you understand how it

I am in the dark as to what the SDR is all about … The remote should work ft-8 now … just set the remote on USB ….. Send and receive ft-8 audio. John K9DX Sent from

Plug and play would require all control operators to access the desktop on a computer located next to the radio. The software would be connected locally. A bother when going from digi to other modes.

It should just be a matter of plug n' play.? Do you want the SDR back?

YES, Demo please.

Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10 Sent: Saturday, July 25, 2020 1:43 PM To: [email protected]<mailto:[email protected]> Subject: RE: [Special]

Each control op uses his own FT8 software. The audio that you would normally hear is diverted to the software and is not heard remotely. The others connected, if decoding, will nor hear the tones. If

I do not think there is anything to do at the remote except the power…. USB and VOLX and away you go … I do it with other RC forb remotes all the time. At this stage in the life of ham radio FT8

As always, there's two sides of a story.? I typically don' make a judgement or act on something unless I hear it from both sides.

.If we can get a couple of you to set this up, we will give FT8 a try. I need to know what we need in the way of software, or settings. Backing down KPA1500 power i the easy part. The hard part is

I want to share this with you. Eric, co-owner of Elecraft took the time to call me at home this morning, explaining the company findings and position on my KRC-2 failure. First of all, there are

My aversion to digital modes has changed as I lost most of my hearing. At one time people were opposed to SSB because it was something new.? I vote in favor to allow? those who want to use it.? The