Well I finally got to building the nano-DDS kit, Nice, very nice. But I had difficulty with the mini360 regulator board. I could not get it to adjust below 8.7v, I had a few in my stock box so no biggie but I tested the replacement before I swapped out the one I had already fitted, yep, the new one adjusts down to 5v no worries so I went ahead and replaced the original. I tested the original outside of the nano kit and sure enough it would not go below 8.7v. I mention this to prospective builders and suggest that you test the module before you fit it. This is just a heads-up to save prospective builders some potential trouble and is absolutely not a criticism. Thanks again for a great project.
Blessings
Wayne - NQ0RP
