Re: T41 Hardware Directions
¿ªÔÆÌåÓý¡°Different power connector on boards, getting to those screws when in a case is torture. I installed a distribution strip on back panel with 2 pin molex connectors to make it easier to take out individual boards.¡± ? I use these:? ? ? ? ? ? Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ VP2EHZ ? Owner - Operator Big Signal Ranch ¨C K9ZC Staunton, Illinois ? Owner ¨C Operator Villa Grand Piton ¨C J68HZ Soufriere, St. Lucia W.I. Rent it: ? Moderator: North American QRO Group at Groups.IO. Moderator: Amateur Radio Builders Group at Groups.IO. ? email:? bill@... ? ? From: [email protected] <[email protected]> On Behalf Of Tim via groups.io
Sent: Sunday, April 13, 2025 1:39 PM To: [email protected] Subject: Re: [SoftwareControlledHamRadio] T41 Hardware Directions ? Couple of hardware changes I would like: Different power connector on boards, getting to those screws when in a case is torture. I installed a distribution strip on back panel with 2 pin molex connectors to make it easier to take out individual boards. Second PC board for front sockets with ribbon (IDC maybe) back to main board, cleans up wiring. Very much agree on moving audio hat to PC board.? Adding pads for memory PB (I found out there is a pad on Tweeny for memory PB). Just some fine tuning HW suggestions. Tim W4YN? ? |
K9HZ