开云体育

Mickey, I'm not saying it makes no difference - I am saying it isn't going to account for a 5° error! g.

Actually with the Nexus it can make a difference. This may not be the problem but it can make a difference. Mickey

The 2 stars used should not cause an issue in pointing of that degree nor cause it to be off on one of those stars (when returned to it). The quality of the alignment - whether the stars were the

Hello Frank, what 2 stars are you using for your 2 star alignment? Mickey

I have the jumpers switched and the nexus dsc pro is now communicating. I did a two star alignment and it pointed good to the first five targets and then on the sixth target it was off by about 5

Hello Steve, The filter will be reset upon a power cycle of Nexus DSC Pro. It is implemented this way to avoid the situations you have described - in case the filter is enabled and by the next time

Hi Serge, We checked the Nexus and we did not have a filter set. The Nexus is on Amelia's 15" Obsession. However the Nexus worked perfectly last night. Since we are just starting out, she would select

Hello Steve, Most likely you have enabled a filter in catalogues. Please go to Find->From Catalogue, press right arrow key to select ‘FILTER’ tab and change the filter to ’None’ using up/down

no need to check the front if you know you have a Gen2 handpad. The Gen2 is not compatible with a Gen3 and vice versa. g.

Thanks Gary for the info. She has the Gen 2 hand pad. And it has the slide switch for 3 different speeds. On the other hand, I have the Gen 3 on my scope. I'll check the labels on the front of the

Steve, Gen2 will use a hand pad - it has the 4 yellow buttons, a green button, and a blue one. The cord is a stereo 1/8" headphone type cable. Also on the front to the left it says PC PORT. A Gen3

Steve, Yes it has been a while. Sorry it wasn't simply using 3 digits for the Messier list objects. Jack Jack's Astro Accessories LLC 38388 Pine Street Pearl River, LA 70452-5192 985-863-2165 (Home)

Hi Jack, We'll check that possibility, but I don't think that is it. Steve PS: Been a while since we talked. HI

Thanks Mickey. We bought this scope (used) a good number of years ago, so I am going to assume it is a Gen 2. Is there a quick way to determine the gen without opening the box? I don't want to do that

Steve, I have only used anArgo Navis with my ServoCat, but is it possible that the Nexus is looking for a 3 digit number for the Messier list - like 031? Jack Jack's Astro Accessories LLC 38388 Pine

Steve forward your comments to Serge the owner of Astro Devices, he will get back to you quickly. I copied him for you but now you have the info. There are too many variables for me to guess at, are

Hi, We have recently purchased the Nexus DSC Pro and tried it last night while at the Texas Star Party. I have a question about selecting an object. We were in the Catalog Messier, and wanted M31 (or

Thanks I will try that tomorrow.

Thanks I will try that tomorrow.

You need to open ServoCAT and change three jumpers to configure it the same way as for Argo Navis - please see the attached photo. You do not need a new cable to connect the serial port on Nexus DSC