开云体育

Thanks for the replies and suggestions.? Responses below. I made no changes to the power supplies I've been using successfully for a while with the AN and the ServoCat units, so it wasn't anything to

As Gary Myers requested, let us resolve Rajeev's issue please. You have done this before in other forums and it is unhelpful. Gary Myers and I are both across our respective products. We have designed

"The DSC light has to come on if you are connected to a DSC. If not then its a wrong/bad (rare fault) cable or internal jumper setting or setup of the DSC. The DSC light should not blink red if the

There are no differences in the ServoCAT's (except through different firmware version levels and Generation levels). The AUX light is a red light - IF you have programmed the latest version firmware

I see significant differences with my ServoCat. "AUX light is orange briefly" I couldn't get this with all possible manipulations, except for one, I didn't use this connector. "HC light goes green"

Rajeev, Focusing on the ServoCAT only - please let me know the answers to the questions I've asked and I can go from there to help resolve this. Note: -Its clear that the ServoCAT is working at least

I can give you another recommendation. Smell inside the Servocat device. If something has burned there, there is usually a smell.

I decided to check this version. I disconnected the internal lithium battery. Argo displayed the inscription RTC battery flat on the second attempt and then suggested entering the date. This is not

Hi Rajeev, With your Argo Navis, it could simply be that the lithium coin cell has depleted and needs replacing. A blank display when the unit is brought up in normal mode is one possible symptom of

Maybe. Like a sequence of random coincidences. Argo burned out, then Servocat stopped working due to a broken cable HC, then the user incorrectly installed the jumper on SkyCommander. Although it

You may have a faulty hand controller cable. The hand controller may be getting power and ground but failing to transmit data to the ServoCAT. I just had this happen on my own telescope. BC

I assumed that a 12V external battery was used. If the user uses AC/DC, then it is his mistake. It has been explained many times and everywhere that high voltage cannot be used in the presence of

Are you certain you have a good 12v supply?

My apologies - I only read the first line about the Sky Comm not being recognized. Which version ServoCAT do you have - is the hand pad connected using a thin round cable with a straight plug at each

The problem is that his device does not respond to the motors control buttons. I do not know how this is connected to the internal fuse. Perhaps it only switches off the motor control chips, but this

see my reply to Rajeev re reversed power. Gary

Hello Rajeev, Sorry for the late reply. So as to why the AN isn't working I can't directly address that. If you accidentally powered it up with reverse voltage I believe it would have been damaged.

I think you mixed up the polarity of power supply for both Argo and ServoСat. The consequences are sad.

I'm looking for help in trying to figure out an issue with my (newly replaced) Servocat unit.? Everything was working until a few days ago, when my Argo Navis unit seems to have suddenly died.?

That sounds like a great tip, big thanks! /Gabriel