For reason I cannot correct, AN will not connect to ServoCAT. ? All was working well until the connection failed the next time I used my OTA. ?AN is functioning normally. ?After the usual startup protocol and a 2 star alignment, the encoders are functioning normally guiding me as I ¡°push to¡± my target. ?Also when I power on the hand control, the function buttons all are working normally when I engage the ALT/AZ motor drives. ?What I don¡¯t hear is the series of 3 double beeps after I power-up and turn on AN to indicate the 2 units have made connection. ?In AN under settings/SERIAL I have the correct parameters: SERIAL 1, BAUD rate, and ServoCAT. ?I have read through the manual but have not found anything that I have missed or not engaged correctly. ?It occurs whether I power by lithium battery or use the AC adapter for power. ?Again it was working fine until it failed and I cannot think of anything that may have happened. ?Any suggestions on what the problem may be? ?
