¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. S227Yachts
  2. Messages
Single Messages Topics Expanded Polls

Re: 1GM10 Stop Cable

AllenJ. Hinkelman
 

Mark, see if you can get a ?hold of Alvarez at Harbor Isle Marina, St. Joe, Michigan for some free advice. He(and I) replaced the panel on my boat several weeks ago because it too was cracked from the engine stop?pull. At the time he explained, at least as I remember it, that the excessive throw was due to the cable not being properly adjusted on the engine fuel injection assembly. I got from the discussion that you periodically have to adjust or shorten it to keep from having to pull it out too far and thus cracking the face plate.
Mine was far more work than yours as the prior owner had a box built around the back and used plastic lock nuts that were real work getting them off-and back on.
Regards, Allen.

From: Mark
To: s227classassociation@...
Sent: Fri, July 1, 2011 9:21:38 PM
Subject: [s227classassociation] 1GM10 Stop Cable

?

I replaced the Yanmar control panel plastic today along with the key switch.? Not a bad job to get the tach, sonalert, toggle switch, bulbs?and everything else?transfered to the new panel and it works fine.? One of the problems I have had over the years has been the engine stop cable flexing and cracking the panel.? I couldn't make myself cut the knockout out of the new plastic, yet anyway.? I have been tinking of relocating the stop cable to a more substantial location.? Have any of you relocated the pull to stop cable to a different location?
?
Mark
Nashville
S2-27 #15
Join [email protected] to automatically receive all group messages.