开云体育

--- In mach1mach2cnc@..., Art <fenerty@a...> wrote:

Monte:

checks the specs on the 990MB on rutex.com. It shows how to put the
drivers in SPI (Serial Periferal Interface) mode so programs can

speak to

it..

You don't need the motherboard, but you have to jumper a pin and put

a 100

ohm on another...

Are you refering to how to wire the boards for running the test
program? Or is there some other way to 'put the drivers in SPI mode'?
I've wired them and have ran both your Rutex Tune and the Rutex tuning
dos app with success on both. I have a bird's nest I need to clean up.

I just picked up on your Rutex Tune program last night, I hope I've
not jumped into the middle of something and missed some instructions
posted somewhere that I should read.

Monte

Monte:

If you've gotten the Rtuex program to run, then your fine. If using
the motherboard, then you need to jumper the pi9ns for SPI mode of
the board, and add a resistor (100 ohms) between two pins to turn on
digital communications to the board. But if you can read the PID
values from a board, then your fine...

Art