--- In mach1mach2cnc@..., Art <fenerty@a...> wrote:
Monte:
checks the specs on the 990MB on rutex.com. It shows how to put the
drivers in SPI (Serial Periferal Interface) mode so programs can
speak to
it..
You don't need the motherboard, but you have to jumper a pin and put
a 100
ohm on another...
Are you refering to how to wire the boards for running the test
program? Or is there some other way to 'put the drivers in SPI mode'?
I've wired them and have ran both your Rutex Tune and the Rutex tuning
dos app with success on both. I have a bird's nest I need to clean up.
I just picked up on your Rutex Tune program last night, I hope I've
not jumped into the middle of something and missed some instructions
posted somewhere that I should read.
Monte
