开云体育

What i don't understand is why the machine is not faster @45KHz compared to the same G-code @25KHz ? Reason for the change would be that i @45KHZ maybe would be able to control a brusless RC motor in

It allows you to run higher pulse rates. Of course your motors and drives have to be able to handle the higher pulse rates. Normally you only need it for stepper drives with high microstepping ratios

HI What will i gain if i change from running 25KHz to 45KHz ? I made a small test, and the system can run both. Simulated time for an item is the same... so what is the difference ? Best Regards

wrote: Paul Will not be taking up disc space. I used to have an entry in the list for each version installed. It really messed up reading the Install/Uninstall list. Had not looked for a while but now

I have a pdf of the pinout that I use for my Anaheim Automatation driver box with Mach3. Email me direct if you want me to send it to you. I just made up some breakout boxes, so I can use all of the

Fortino: No, Slaved motors must be the same steps/unit.. Thanks, Art www.artofcnc.ca Videos And Support Forums http://www.machsupport.com Users Map: http://www.frappr.com/machsupport

Hi: changed to the breakout board when the buffer reaches 100% I see all Axis stop, till the buffer goes down. My Question is, The buffer causing the lost steps and if so How can I increase it

Hi Jacques: Ive forwarded that one to Brian, but it could be its just too old. Download 1.90.041, it has LCam 2.53 in it.. Thanks, Art www.artofcnc.ca Videos And Support Forums

JP, Yes you can do that and I offer a board to connect it all. Monitors position and halts if a preset following error is exceeded. www.rogersmachine.net Thanks, Ron fivespirate <FiveSPirate@...>

question lazycam v1.0 if i have dxf file with line or point no problem the router go down to cut line and go up make the point go down go up so when it moving to the next one the router is up N2

hi oscar i have the same problem ,its just that i dont want to use indexer lpt. i want to use mach3 because i already know how to use it i was just wondering what your step and dir pins are??? before

I have a second parallel port card installed in my contoller that I want to use for my I/O panel. I'm using a keyboard emulator to handle most of the inputs, but I'm now stumped on outputs. I have

The only ones that show here are the current versions that are installed. Corrupt registry perhaps? Steve Blackmore --

I have Mach software, HobbyCNC board and stepper motors, can I add XYZ encoders? Has anyone been succesful with this combination? I would sure appreciate some advice. I am looking at the board from

Paul: Each version overwites the old. To remove it all, just dleete the folder. No uninstall is necessary.. Thanks, Art www.artofcnc.ca Videos And Support Forums http://www.machsupport.com Users Map:

Hi All I had gone into Add or Remove Programs to remove some old files and noticed all the versions of mach their.I tried to remove the old ones using the remove button in the Add or Remove Program

Hi. I've picked up an Animatics C5200 2 axis servo controller, but I have no docs or software. Anybody have docs, software, ... that they can pass along? I've contacted Animatics, but they no longer

Thanks Art. Michele --- art <fenerty@...> wrote:

The only problem with not removing ACPI, and trying some or all of the other fixes, is that if you end up HAVING to remove the ACPI afterwards, you will have to go back and do all of the other stuff

Hi michele: What your creating is a point cloud file. They dont contain any letters. You must use a CAM program that will load point clooud files to replicate the surface. The digitiser is use donly