开云体育

Does the Hawiian shirt protect from stray electromagnetic radiation? :)

Mariss: You scare me... alot!! Thanks, Art www.artofcnc.ca Videos And Support Forums http://www.machsupport.com Users Map: http://www.frappr.com/machsupport

It's obviously a pointless stunt as presented. At 24VDC the motor was developing 55W and most of that energy went into accelerating and decelerating the screw. At 75VDC I was getting 2.5 meters/sec

Pretty violent R&D. <mariss92705@...> wrote: 22lbs to load. later darn

Not so sure you want that:-) In the previous run I had the G201 cranked up to 75VDC; the motor develops 165W+ at that voltage. On the 1-TPI screw it developed 22lbs (10kg) thrust at 10 meters/min. It

Mariss Freimanis wrote: Great stuff Mariss , but I think at least we should of got the full gory version Swearing, Blood n all! --

Hi, Cross-posted from the geckodrive group. I thought people here might be interested in it. -------------------------------------- I uploaded a short video that has an axis tooling along at 3,932

Jerry, They should work OK if you have the 5 phase drivers to go with them. Bob Campbell Bob Campbell Designs www.Campbelldesigns.com Mach 2/3 breakout boards Relay boards Spindle Speed boards Stepper

no, the essential difference being that a THC produces motion orthogonal to the tool path, the tool path just carries on as normal. In EDM you have to slow and even reverse the tool path as necessary.

Has anyone used the 5 phase Vexta motors and drivers with Mach 3? I assume they would work fine, but I thought I might check. Jerry

Hi all, I have a modIo pendant with MPG on pin 14, 15 and there is conflict with Grex encoder 5, if i power off the Grex, all work fine but with, the value are refreshed with 0... Any ideas? Thank

BTW Because if all the talk about RC Stuff I just looked at Castle Creations Web Site after a few years. They have grown a lot and no have a Beta Tester Program. Maybe some of us would like to use

Hi Eric: YEah, never remove acpi unless you KNOW its creating a problem, some motherboards need it for some drivers. All my computers are ACPI and no ill effects are seen... Thanks, Art

Hi Johnny: Plugin version will start to appear in about 2-3 weeks. They will quickly build form there to completion. Yes, the Jog% shoudl slow down the jog. It does here anyway.. Thanks, Art

Hi Art, Thanks for help. After installing Windows XP again all is working fine now, even in 35 KHz mode ;-) The only difference in the installation is that now i used ACPI and the first time i

Les and Hugh thanks for answering guzakaka's questions. The Phoenix brand ESCs by Castle Creations (and I am sure others) keep pushing the envelope. The last one I bought but did not mount was 45A

Art: Should Mach 4 jog at rapid even if the feed rate percentage is set less than 100%? Also, can you speculate when the plugin for Mach 3 will be completed for the Grex. Thanks, Johnny

Greetings One more comment on using Radio Control motors and speed controls for small milling spindle motors. Remember that these motors are designed to be air cooled by the planes speed through the

An inrunner has the windings on the outside and the rotor spins inside them. An outrunner has a bell shaped rotor and the windings are inside it. This means that the majority of the casing actually

Hi Scott: Send me your mach3mill.xml, that probably easier. :) Thanks, Art www.artofcnc.ca Videos And Support Forums http://www.machsupport.com Users Map: http://www.frappr.com/machsupport