开云体育

I need to get you in contact With Todd.. He should be able to set you up! Mail me off list and I will get you in contact with him Thanks Brian

Brian I gathered they were aware of the password issue... Also is there any intention of adding older Mill Wizard management to the site. It seems I purchased to early and have to go thru support for

From what I saw last week, onthe license server, you can deactivate a license, but not delete it. Andy Wander _____ Sent: Monday, March 02, 2015 8:16 AM To: mach1mach2cnc@... Subject: Re:

The License portal is a work in progress! You should be able to delete your license and shift it to a new PC... I will report the changing of the password issue.. Thanks Brian

I think I would stay far away from this type of solution. These chips are designed to debounce human activated switches. They will introduce a delay that could be significant; they are another point

i think i figured that out so what i need to do is to store either the current fixture choice and then restore it when i need to or to do it myself using the DRO and saving and entering the offset

You can't turn them on or off. You either need to switch from one offset to another, or set them to zero when you want them to be "off". Gerry

i can not figure out how to turn fixture offsets on and off. it looks like it is easy to turn tool offsets on and off but i can not provide a Y offset in a tool offset unless there is something i am

i just bought some of these debounce chips for another application but have not tried one yet. even thought they are tiny surface mount, they have just power and in and out switch connections so they

The problem with setting your debounce to 1000 is that it can overtravel before stopping. I like to keep the debounce down to around 50. Dan

The debounce should be set at 0, imo, ime. If you get false triggers, the better solution is to fix the electrical noise thats causing this. Shielded cables ? Grounded at one end only ? Proper

If it's the same as Mach3, Cycle Start will do it. Andy Wander _____ Sent: Saturday, February 28, 2015 7:08 PM To: mach1mach2cnc@... Subject: [mach1mach2cnc] Feed hold in Mach 4 I finally

I ran a short file yesterday about 40 times and the reset was never triggered. Today I run a long file and 12 mins into the file the reset was triggered. I had setup both home and limit switches on

i have solved my need for offsets to account for material thickness changes by creating a bunch of buttons each of which runs a gcode to choose a fixture that has the offsets i might need. 8 buttons

I finally got mach 4 somewhat configured and cutting air on my little Shapeoko 2. I then hit Feed Hold.. Worked ok but then I couldn't figure out how to release feed hold. The box wouldn't toggle and

For me, it was actually very easy to get a new license. However... There needs to be a way to delete a license. I already have used 3, and have not even used Mach4 on a PC with a machine attached.

Never mind I heard from Scott and the password reset is broken and he will help me out. But I will say this isn't as easy or trouble free as we were promised back in the beginning... But then neither

Well i have bought nfw, mach4, and darwin.. But when I went to use hem I downloaded the latest versions of 4 and Darwin my licences no longer work. So I wrote support and asked for new licences and

Did you check this with him? Thanks, Dan

I will second that 100%. Deskproto is the best for 4th axis. Don Clifton Sent from Don Clifton's IPad Air