开云体育

----- Original Message -----
From: Bob Campbell
To: mach1mach2cnc@...
Sent: Wednesday, February 25, 2004 6:06 PM
Subject: Re: [mach1mach2cnc] Power suply, Campbel Board and gecko drives


Robin,

What do you need help with?

First you will want to download the Sound logic XML file from my web page
www.camobelldesigns.com . The XML file will set you pins on the parallel
port correctly. Copy the XML file into your Mach2 directory. When starting
Mach2 select Mach2 not Mach2 mill and select the Sound Logic XML file
procedure.

For wiring the Gecko drives you should look at the pinout information from
Gecko drive. For the G201 you will connect you power supply common ground
to pin 1 of the gecko drive and the + voltage to pin 2 (use a fuse in this
line). The step and direction wires will go to pins 8,9,10. 10 is the +5
volts from the breakout board, 9 is the step signal and 8 is the direction
signal.

I am working on a detailed set of instruction and a wiring diagram for the
breakout board to the Gecko 201/210 drives.

Bob Campbell
----- Original Message -----
From: "INDECO" <indeco@...>
To: <mach1mach2cnc@...>
Sent: Wednesday, February 25, 2004 2:37 PM
Subject: [mach1mach2cnc] Power suply, Campbel Board and gecko drives


> I am soooo confused!!!
> I have a power supply from and a Campbell
board from and the
Gecko g201 , and 2-g320 drives.
> Just about finished with the power supply and at the point of wiring the
drives and board and I don't understand any of it at all.
> Does anyone have this setup and can you send me pics if you do?
>
> Thanks, Robin
>
>
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>


Yahoo! Groups Sponsor
ADVERTISEMENT





------------------------------------------------------------------------------
Yahoo! Groups Links

a.. To visit your group on the web, go to:


b.. To unsubscribe from this group, send an email to:
mach1mach2cnc-unsubscribe@...

c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.