Try turning off the screen saver.
Don
--- In mach1mach2cnc@..., "johnb50002000"
<John.Burke@a...> wrote:
Hi,
I am having the same problem with 4.0. I went through the same
checks
and balances you did with the same conditions, with the pulse at
25000 for a short period of time until dropping to about 4500
pluses.
IM running XP professional on a Dell lap top. I don't know if this
makes a difference from XP home addition.
Best regards,
John B.
--- In mach1mach2cnc@..., "bartelian" <bartelian@y...>
wrote:
I just downloaded Mach2Mill and tried to configure it. The manual
says I should have about 24,600 Hz. My Puse Frequency starts high
but goes down to 1100-1200 Hz., the program will keep running
(very
slowly) until the screen saver kicks in. Then when I hit a key to
return to the regular screen the P/Freq will go up to 25,500 Hz
for
about 15 sec and then drop dramatically low again. I cannot
maintain
a consistant Pulse Freq. over about 1300 Hz.
I am running M2M Release 1.90 on a Compaq 2.6GHz, 512 Mb. So far
I
checked to make sure Quicktime (Qtask.exe) is not installed, made
sure LAN is set to 100Mbps, disabled the screensaver, cleaned the
system with SpyBot, and started with a clean boot. So far nothing
works.
Thanks in advance for any help. The Program is just what I want,
but
don't know if it will work on my computer. Bill B
