--- In mach1mach2cnc@..., art <fenerty@...> wrote:
Thanks for the reply Art,
When the program E Stops there are no limit led lit at all if I
hit reset the program will run again. I have run the ocx driver test
a number of times but I must not be the sharpest knife in the drawer
as i dont get the idea of it at all. When I run the test it runs
fine and reports that the test is finished Is there a pictorial
example somewhere of what a good waveform looks like so i can
compare? The frequency remains fairly constant throughout the test ie
23 600 +or -.
Sorry to be a pain in the %$#@ you must have answered thousands of
questions like this before.
Thankyou very much, Justen
Hi Junsten:
When it Estops, do you get a limit switch error? As to the speed,
make sure
you run the drivertest.exe program and see that its got a good
waveform.
Thanks,
Art
www.artofcnc.ca
Videos And Support Forums
Users Map:
----- Original Message -----
From: "callum002c" <callum002c@...>
To: <mach1mach2cnc@...>
Sent: Sunday, June 04, 2006 11:31 PM
Subject: [mach1mach2cnc] gecko 201 slipping/losing steps
I am running a 3axis gantry with gecko 201's and a 750 mhz laptop.
The steppers are Mclennan nema34 triple stacks 72 volts.
The axis run 5mm pitch ball screws, mach2 is set to drive at
45000 Hz
