Mike,
That was my thought At first, then I remembered this little guy doesn¡¯t have any limit switches on it. ?
I¡¯m wondering if something could¡¯ve happened to the parallel port itself within the laptop computer.?
I say this because I tried two different control boxes and it made no difference.
Thanks for your input,
Chuck
toggle quoted message
Show quoted text
-sent from my iphone --
On Jan 12, 2024, at 10:36?AM, mike allen <animal@...> wrote:
?
??? ??? Limit switch & wires all good ?
animal
On 1/12/24 10:02 AM, Chuck Kahler
wrote:
I have a TAIG desktop Mill with a PMDX ¨C 122 motion control board
that utilizes a parallel port.
?
The machine has always run without problem and in the middle
of a 15 minute milling job it stopped about halfway and I cannot
get the machine to respond no matter what I try.
?
I even replaced the control box, which I had a spare, that
?included the?PMDX
-122 motion control, and Gecko drivers, and that did not help.
anybody have any ideas what could¡¯ve caused this?
?
Thanks,
Chuck
?
?
?
