Re: Question about Macros and dialog box's, and or messagebox
|
Ok Thanks Brian
I will try to make a short video and send ?you a link if that would be better for you, I always don¡¯t explain things clear, I know what I¡¯m trying to say but most of time its not clear to others
?
Thanks gary
I tried a video? but the cross hairs on the gcode display screen are so small and faint its not showing up in the video can they be enlarged or color changed
?
Sent from for Windows
?
From: Brian BarkerSent: Tuesday, December 21, 2021 2:54 PM To: [email protected]Subject: Re: [MachCNC] Question about Macros and dialog box's, and or messagebox
?
Gary,
I am working with an OEM now but if you can show one of the techs here I will get on it once they can show it to me. I am sure I can figure it out :)
contact me off the list at brianb?? at machsupport.com
?
______________________________
?
Brian Barker
?
Webpage:
On 12/21/2021 1:40 PM, Gary wrote:
Hi Brian
? I think i had asked about this issue before, but i will refresh on it...
I have a major problem with the axis's being centered, seems to happen if i do a manual jog? then zero the axis's and re gen the file the dro's read zero but the cross hairs on the tool path always start at the last jogged to position.. and the dro's are showing zero for me is the parts center, if i go and run the job its jog's way off it almost seems like it jogging back to were it was before i did the first jog move and re zeroed the dro's.
It just seems that for some reason if i jog, re zero and re gen then runt he? gcode it just seems almost like it thinks the first jog point is zero even though i re zeroed the dro's? and it jogs to that position and starts the cut, and thats not in the parts center..
Could i have a setting wrong? looked at them over and over but not sure, and it does the same thing even if i use a different computer..
Gary
|
