Hi Brian
? I think i had asked about this issue before, but i will refresh on it...
I have a major problem with the axis's being centered, seems to happen if i do a manual jog? then zero the axis's and re gen the file the dro's read zero but the cross hairs on the tool path always start at the last jogged to position.. and the dro's are showing zero for me is the parts center, if i go and run the job its jog's way off it almost seems like it jogging back to were it was before i did the first jog move and re zeroed the dro's.
It just seems that for some reason if i jog, re zero and re gen then runt he? gcode it just seems almost like it thinks the first jog point is zero even though i re zeroed the dro's? and it jogs to that position and starts the cut, and thats not in the parts center..
Could i have a setting wrong? looked at them over and over but not sure, and it does the same thing even if i use a different computer..
Gary
