Ok thanks, but this problem with the toolpath being off center, has become a real problem for me..

?

I just ram a job this morning.. I started by probing to find the center of part, when centered I zeroed the X and Y

Then loaded the tool and probed the tool Hight so that was set, then loaded the g code file.

Checked the X and Y they were at zero the z was at the correct height.

Started to run the job the X and Y went no where near the correct position and the z dove into the part… wrecked part now

?

So I flipped over and did the same thing exactly and it cut prefect . .

?

I have had this happen before when I run the part the first time if I re zero center everything and try again it runs fine..

?

I have tried this on 3 different computers also

?

Any suggestions,

?

Gary

?

Sent from for Windows

?