my version is old, i will check out the new one.
On 5/11/2021 11:52 PM, terry mckinley
wrote:
Not sure how you think CamBam is old the last release was march
2020 but an update is being worked on.
simple in cambam load in your old project and just change cutter
size and re produce gcode.
--
Best regards, Spencer Chase
67550 Bell Springs Rd.
Garberville, CA 95542 Postal service only.
Laytonville, CA 95454 UPS only.
Spencer@...
(425) 791-0309