This is a very good system.
( I would drive the z axis at 1:3, for more 300% torque =
acceleration.)
Try Arts test at the lower acceleration, and let us know.
It will likely make a difference, or lead to clues on where the
problem is.
On 17/02/2015 15:04, 'Andre Schoonbee'
andresch@... [mach1mach2cnc] wrote:
?
In
the control box I have 4 x Gecko G203V Stepper drive
units
?
34HSX-104D
Stepper motor (2 x motors for X-Axis, 1 X motor on
Y-Axis)
23HSX-102D
Stepper motor (Z-Axis)
?
X-Axis
drive system:
15
tooth Pinion
15T
T5 Timing pulley
T5
420 Timing belt
60T
T5 Timing pulley
20mm
Linear Guides and 20mm Linear Blocks
?
Y-Axis
drive system:
20
x10mm Ball Screw and 20 x10mm Ball Nut
15mm
Linear Guides and 15mm Linear Blocks
?
Z-Axis
drive system:
12x4
Ball Screw with 12x4 Ball nut
15mm
Linear Guides and 15mm Linear Blocks
?
?
?
?
?
What motors are you
using;
Ie what is your motion-control train ?
Steppers ? Drivers ? Volts ? Belts or couplers ?
Breakout board ?
Do you only have 86.x steps / mm on x ?
On 17/02/2015 14:31, 'Andre
Schoonbee' andresch@...
[mach1mach2cnc] wrote:
Hi
Art
?
I
will try this as well.
?
My
Motor Tuning settings for all my axes as the
following ¨C starting with the Z-Axis:
?
Z-Axis:?
Steps per = 494.0698539
???????????????
Velocity mm¡¯s per min = 5191.0
???????????????
Acceleration = 100
?
X-Axis:?
Steps per = 86.95652174
???????????????
Velocity mm¡¯s per min = 8328
???????????????
Acceleration = 306.1875
?
Y-Axis:?
Steps per = 200.3234631
???????????????
Velocity mm¡¯s per min = 6228
???????????????
Acceleration = 157.15116
?
For
what it is worth
--
-hanermo (cnc designs)
| |
This email has been checked for viruses by
Avast antivirus software.
|
--
-hanermo (cnc designs)
