开云体育

What I meant to say is of course "lasso one of the anchor points", depending on the direction in which you want to enlarge the rectangle. Ryu

I don't know if it is of any help after all the advice already given, but to change the size of a rectangle simultaneously in two directions with the drag tool I have to lasso the anchor points which

The on-screen background color does not affect the printed output, in my experience.? That is true whether or not I have "Print Monochrome" selected, at least when printing to PDF.? I suppose Your

I have succeeded, but without really resolving the issues: 1. I have the background colour for both schematics and waveforms set to white, because that saves a lot of toner when printing out. I think

Thanks, Andy. -- This email has been checked for viruses by AVG antivirus software. www.avg.com

Thank you.

To which I replied, "I do not think so".? But I'm wrong.? I was using the "Move" and "Drag" buttons incorrectly in this case.? "Move" moves the entire rectangle.? "Drag" drags only the lasso'ed

There's a Control Panel setting to flip the mouse wheel options, try changing that. I normally have that setting checked and the touchpad on my laptop works well for me. -- Regards, Tony

As for #3 below; Hit the "S" key. Drag a box around an entire edge of a rectangle, top to bottom, or right to left. Drag that edge of the rectangle to a new desired position. All for now Sent:

Are you sure they are enabled?? Right-click in schematic window > View > Show Grid.? Or Ctrl-G should toggle them. Zooming in and out MIGHT help make them marginally more visible, but my eyes are

It is 24.1.1.0, windows 64bit

What version of LTspice? Jim

In that case, I suggest taking the issue to ADI's Engineer Zone. -- This email has been checked for viruses by AVG antivirus software. www.avg.com

I am still using version 24.0.11, and I am finding some problems with drawing a block diagram of a multi-stage circuit as a schematic. I know that LTspice isn't intended for that, but It's much

My touchpad works as intended on all other platforms and the windows system itself, only flipped directions on LTspice.

If there is, it would be in the settings for the touchpad on your computer, not in LTspice. -- This email has been checked for viruses by AVG antivirus software. www.avg.com

When I move the circuit graphs using mouse, it works fine, but when I move them using two fingers on the touchpad of my laptop, they shift the other direction (meaning when my fingers drift left, the

Hello, Lately, I needed to add an external piezoelectric buzzer to the internal ringer of my (bell) phone. I found, in the group’s archive, a circuit of Piezoelectric Buzzer, BuzFB.asc , made by

They are almost exactly the same thing anyway. Andy

You might want to consider MODULATE rather than MODULATE2. Sorry. Jim