开云体育

I am still using version 24.0.11, and I am finding some problems with drawing a block diagram of a multi-stage circuit as a schematic. I know that LTspice isn't intended for that, but It's much simpler to use than some other drafting apps. The problems are:

1. I can't see the grid points. They have always been minute but now I can't see them at all. They used to be more visible on print-outs of schematics.

2. Drawing a wire with CTRL held down doesn't allow the wire to start and end off-grid. It's the same if I draw lines instead of wires. I can't find a 'Snap to grid' check box to untick.

3. Is there any way to change the dimensions of a? rectangle after it is drawn? I guess not.

Would it be better to use the symbol drafter?