开云体育

In that case, I suggest taking the issue to ADI's Engineer Zone. -- This email has been checked for viruses by AVG antivirus software. www.avg.com

I am still using version 24.0.11, and I am finding some problems with drawing a block diagram of a multi-stage circuit as a schematic. I know that LTspice isn't intended for that, but It's much

My touchpad works as intended on all other platforms and the windows system itself, only flipped directions on LTspice.

If there is, it would be in the settings for the touchpad on your computer, not in LTspice. -- This email has been checked for viruses by AVG antivirus software. www.avg.com

When I move the circuit graphs using mouse, it works fine, but when I move them using two fingers on the touchpad of my laptop, they shift the other direction (meaning when my fingers drift left, the

Hello, Lately, I needed to add an external piezoelectric buzzer to the internal ringer of my (bell) phone. I found, in the group’s archive, a circuit of Piezoelectric Buzzer, BuzFB.asc , made by

They are almost exactly the same thing anyway. Andy

You might want to consider MODULATE rather than MODULATE2. Sorry. Jim

john23 asked: Is there some bahvior model in LTspice which could help me represent this device in simulation? What level of detail do you need to simulate? If it is just frequency out vs control

Adding a bit more to this: What John Woodgate is talking about, is the special function named "MODULATE" (and its counterpart "MODULATE2") which you can find by typing "MODULATE" into LTspice's

I think that the MODULATE device will do this, but needs other devices to produce the input signals it wants, and those? that the YIG wants, from those you have available or are produced by the

Hello, I have a YIG device which? has two inputs. Tune input at 2V puts my YIG to 9.4Ghz and 10dBm FM input is current? input which moves the output 100Mhz each mili ampere. I can measure the

For the tube amplifier schematic, ITS step takes 44 Direct NR iterations (totiter=44) to converge with default settings. I tried to set *.option ITL1=10* for .tran 0 10m analysis just to check that

Hello eT, At first my confusion had me looking for a diode named "p". Dp begins with D for diode but, now I realize that Dp is the output node of a BUF element as you have described. Removing the

Actually, in this case buf "ADDEL" output "DP" has a delay associated with it that isnt used. It might have been intended for simulation of setup/hold time. It will take some testing.

Spice 3f3 user's manual is /g/LTspice/files/Temp/man_spice3.pdf

Those are harmless warnings. They can be ignored.? We get them all the time.? If you really really want to make the warnings go away, connect a 1G resistor from the node to ground.? Voila, warning

Yes, that would be useful, thank you ! Carlo.

Hello All: WARNING: Less than two connections to node xlogic:u1:dp. This node is used by a:xlogic:u1:ddel. xlogic:u1 is a 74HC74 from the 74HC_v.lib of which my copy has the following header; *

I have a good PDF manual for Barkley spice, if it's needed.? Yahoo Mail: Search, Organize, Conquer