LTspice Yahoo Group readers,

I am shopping for a new home computer optimized to run LTspice and have been corresponding with Orbital Computers. ? Danny Payne, the owner there was willing to benchmark LTspice for me.? He downloaded the new version (LTspice XVII) and tried running some of the test jigs.? He chose the 3752-1 test jig, which was a very good choice for someone not familiar with LTspice because he chose a file that maxes out all eight of my work computer's threads.

However, it turns out that either the 3752-1 model or its test jig is not well written because it throws lots of Def Cons with the default simulation settings.? It runs much happier and faster with the Alternate Solver selected, Reltol relaxed to = 0.01 and T rtol set to 7 (click the Hammer icon to access the Control Panel and then click the Hammer tab to access the SPICE settings).

On my (4 cores / 8 thread) Xeon E3-1240 v3 @ 3.40GHz with 8GB ram (NVIDIA Quadro K600) at work, the SPICE Error Log reports a run time of around 126 seconds (once the Alternate Solver has been selected and Reltol has been set to 0.01 and Trtol set to 7).? NOTE: Do not plot any traces when running this benchmark.? With the same simulation settings, the old LTspice IV runs this test jig in 137 seconds, which is about 8 percent slower.

I am going to send Danny Payne this message and have him run the benchmark with the same settings on an LTspice optimized computer platform and report his results (as well as the system configuration details).? It is interesting that he recommends Windows 7 for all CAD programs.

It would be fun to see what run ti mes other group members report for this benchmark.

?