On Sat, 13 Jul 2013 23:01:59 -0400, Julio wrote:
I am looking at simple RC circuit with a time constant of 1 sec and a 6 V
battery.
Doing a transient analysis, at t=0 the capacitor is already fully charged
at 6.0 volts!
I don't recall giving initial conditions for the cap, so if I did not
shouldn't the cap start
In a fully discharged state?
Look at the .tran card (it's on the schematic.) Right click
it and look near the bottom of the dialog box to find "skip
initial operating point solution" and check it so that this
step will be skipped. Then re-run the solution.
Jon
