Andy, thanks for responding. I forgot to add after asking if this was a stupid question, whether I had worded it badly.
How about this:
I use
.ac dec 201 10 100k
then how do I make an output table of
V(out) at specific frequencies?
I can change the command line to
.ac dec 500 10 100k
which is only 2000 points, and not slow down the analysis much
is there a way to say, ask for
V(out) at freq=20.5956780Hz?
V(out) at freq=33.4585746Hz
.
.
.
and so on to make a table of these values that I could then use elsewhere?
--- Andrew.Ingraham@... wrote:
From: Andy <Andrew.Ingraham@...>
To: LTspice@...
Subject: Re: [LTspice] Help! How do I do find maximum signal easily!
Date: Thu, 11 Jul 2013 23:26:31 -0400
I can't believe no one has responded! Was this a stupid question?
Maybe not. But a complicated one. I, for one, have trouble understanding
what exactly you are asking. Sorry.
Andy
