--- In LTspice@..., Charles R Patton <charles.r.patton@...> wrote:
I would suggest a PWL file driving a voltage source and controlling the
switch resistance as the PWL could model the particular switch
bounce/contact resistance characteristics that will vary considerably
depending on the actual switch being considered. I.e., a wall switch
looks a lot different than a rubber membrane switch, snap-disk switch,
slide switch, or keyboard switch.
Regards,
Charles R. Patton
If you need help trying to figure out what kind of bounce you need to model, check out the wonderful article on switch bounce at:
. With this information as a starting point, you can better determine what type of waveform to model.
Carl B. Van Wormer
P.E. AE7GD
carl@...
www.testecvw.com
