--- In LTspice@..., "Helmut" <helmutsennewald@...> wrote:
Autoscaling can't be switched off. You can workaround this
by using a plot settings file which you reload after each
simulation run or you could add an upper and a lower trace,
e,g. +10V and -10V.
That is true, and I have defined the space-bar to reload the settings, so it behaves similar to in the schematic editor. I have set the scales to make it easy to compare the voltages/currents in my converters.
However some transient simulations take 20-30 minutes to run, and when you reload the plot settings, it gets rid of the cursors. Plus every 5-10 seconds, the plot re-autoscales as more results are added to it. I am having a fighting battle. I have also considered using min/max, but I like the scales I've chosen with 55V on the left and 550A on the right, and I'm not sure I'd get them to match as nicely.
I really want to rant, and I'm sure I want to connect someone to the output of the power supply, but to be honest, I am so thankful for LT Spice that I can only manage "Thank you Mike" :)