开云体育

So I am modelling the magnetic core in Pspice model editor

I got the B-H curve values from the TDK mcironas ferrite design magnetic tool and uploaded that into pspice model editor

I also referred to the for modelling the magnetic core

The values mentioned in the book matches with the ?

But the issue is the Pspice model editor uses Jiles Atherton model to calculate the parameters Ms , A , C and K

When I give the B-H curve values into the Pspice model editor , the model editor internally somehow calculates the above mentioned parameters which is way too far away from the ones mentioned in the book (there is no values of MS , A , C and K mentioned in the datasheet)

And when I give the parameters from the book into the Pspice model editor , the curve does not fit and I am not getting the expected results

Any idea on how to resolve this ?

Below table shows both the book values (2nd column) and spice model editor values (3rd column)

Parameters	Values from the book (MS is calculated)	?Values extracted from curve by Pspice Model
MS	342110	360595.7907737
A	1.26	10.185
C	2.60	0.39337
K	4.194e3	8.246