On Fri, May 9, 2025 at 07:23 PM, <guilhermesouzam01@...> wrote:
My load is purely resistive, so in theory, the waveform I should see across the resistor will be square-shaped with the same RMS voltage as the supply voltage (Vcc) of the circuit.
However, when I simulate my circuit, the waveforms appear distorted and noisy.
Are you sure you looked at the voltage
across the load resistor?? The easiest way to do that in LTspice is:
- Position the cursor over one end of the resistor so that the probe turns red.
- Press and hold the left mouse button.
- Move the cursor to the other end of the resistor until the probe turns black.
- Release the mouse button.
?
Andy
?
