¿ªÔÆÌåÓý

  1. LTspice
  2. Messages
Single Messages Topics Expanded Polls

Re: Is there a way to make node numbers appear on LTSpice schematics?

 

¿ªÔÆÌåÓý

Well, except for net 0, common or ground. That is known as the schematic is built.

Jim

On Jul 17, 2023, at 1:01 PM, Jim Wagner <wagnejam99@...> wrote:

Those run-time node and net numbers can vary from run to run, especially after adding a component. AFIK, they are not known until the sim runs.

Jim, Oregon Research Electronics

On Jul 17, 2023, at 12:33 PM, Chris - G0LOJ <chrisbudd606@...> wrote:

I believe that nodes (or nets) can be user-named, and that curves on an LTSpice plot can also be user-named, but sometimes it would be simplest to use the node numbers assigned by the software during the building of a schematic. Is there a way to cause those node numbers to be displayed on the schematic. Thanks, Chris.


Join [email protected] to automatically receive all group messages.