开云体育

Not sure that a higher VA rating is really necessary for this small of an isolation transformer. "It is possible to estimate the output voltage at intermediateloads since load regulation varies in an

The Vintage SSB Roundtable meets every Tuesday night at 7:00 PM CA time. Early check-ins start at 6:30 PM. Frequency is 3895. It would be wonderful to hear some of you on from the Halli group! Bob

There is a vintage ssb net I ran across a few months back and it is not brand specific. Have to page back through my scratch sheets to find the info. Think they were followed by a Heath net. Someone

Walt there use to be a net but sadly i have not heard it in years. hope they just moved freq 73 Tony WA4JQS -- This email has been checked for viruses by AVG antivirus software. www.avg.com

Does a Hallicrafters HF net exist.? Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters A majority of acceptance is not proof of correctness. https://wd0gof.com/bible-study/commentaries/

Ron, I just measured my s38b and it draws 208 mA with a supply voltage of 121 VAC. I think I would use a transformer with a good safety headroom. Maybe 50 VA so it doesn't get hot. 73 Don ve3ids

Hi folks, I am restoring a Hallicrafters S38-B receiver and want to add an isolation transformer. So that I can select the correct transformer, I need to know the actual current the S38-B draws. I

And I have it now thanks to Pete! Really appreciate your product!

wants schematic for 1st version not 3rd version. Pete, wa2cwa On Wed, 9 Apr 2025 03:11:43 +0000 "waltcates via groups.io" <cateswa@...> writes: SEE attachement. Walt Cates, WD0GOF

Sent from Yahoo Mail for iPad

I bought an XM receiver at a hamfest a few years ago. It was "open". To use it, you tune your FM car radio to an open frequency and simply listen to it. No hardwire necessary. I assume they still work

SEE attachement. Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters A majority of acceptance is not proof of correctness. https://wd0gof.com/bible-study/commentaries/ ________________________________

Working to restore a S-107. This is the first version with the 6SC7 tube before they went to the 12AX7. I can only find a schematic for the MK1 & 2 which use the 12AX7. Someone has done a half hearted

There is an audio to FM stereo adapter that was popular a while ago, takes earphone and converts to FM stereo for your car radio to pick up ________________________________ Sent: Tuesday, April 8,

You also can get a cheap fm transmitter that plus into your sirius's unit, and transmits to the fm band. ?Again, very cheap and Amazon likely has them.

Google it! Then go to Amazon and buy it. 73 dave wa3gin [email protected]> wrote:

You can get a device that is a casette-shaped interface that you put in the casette deck, and that has an aux input. Since it is a bit dated, look for a used one on eBay perhaps. Cheap.

I would like to add SiriusXM to the radio in my 1999 Chevy Tahoe. It doesn’t have an Aux radio input. Does anyone know of a way to input the Sirius audio through the cassette input (some sort of an

Ed and Walt, thanks for that input. ?I will take your advice and will report back. 73

As Ed stated the most common cause for the calibrator failure is the function switch. I would clean the switch, clean the pins and sockets of SO2 if still not working check the voltage at the pin 2 of