I just finished pretty much a complete overhaul of a nice condition (physically) SX-28A. Replaced just about every resistor and all caps.
?
Radio is working well except for a 120hz hum. When I switch the Bass in, the hum goes away.
?
Yes, there is ripple on the plates of the 6V6¡¯s, about 6vrms, but that is there independent of the bass switch position. The output side of the HV filter is clean, no ripple. I paralleled another 47uf 450v cap across the choke input cap and there was no difference.
?
I double checked the wiring against the schematic along with component values. Is the schematic correct in this area? I found once schematic error maybe there is another?
