开云体育

I sometimes operate from other parts of the house via AnyDesk mainly working FT8. ?I want Commander on the same screen as WSJT-X/JTAlert as well as DXKeeper, DXView, SpotCollector and PathFinder.

+ AA6YQ comments below

I would like to see some macro buttons added to the right side of the spectrum/waterfall window similar to the way you have the fequencies on the left side. ?I have several K4 macros I use to set the

+ AA6YQ comments below + I added material from that post to the "Size of the Spot Database" section of "Optimizing SpotCollector's Performance" in

+ AA6YQ comments below + When Commander is interacting with a Flex Signature transceiver, simplex operation utilizes Slice A for both RX and TX. Split operation uses Slice A for RX and slice B for TX.

Well written and objectives are now understood! TKS Dave, 73!

I think I got it. Is there a way to make a selected spot go to the slice set for TX instead of always going to A? -- 73, Greg - AB7R Flex 8600 PGXL & TGXL AG

Thank you. Problem solved. + How did you solve it? 73, Dave, AA6YQ

Thank you.? Problem solved. 73's Jan, ZS1IS

Thanks Dave.? I will bypass Slicemaster and see how it goes.? Appreciate the assistance. -- 73, Greg - AB7R Flex 8600 PGXL & TGXL AG

+ AA6YQ comments below + There is no interoperation between DXLab and SliceMaster. + There are two supported forms of interoperation between WSJT-X and DXLab: direct, and via JTAlert. See

This is the setup I am trying to use now.? All software is current. dxl is using flexsig and slicemaster is using whatever it uses to connect to ssdr.?? Seems to set WSJTX to HRD for the rig on

+ AA6YQ comments below Just built a new Win11 box and installed a fresh copy of DXLab. Successfully imported my QSO database from DXLab on the old Win10 box. Fresh app talks to the rig and logs QSOs

Just built a new Win11 box and installed a fresh copy of DXLab. ?Successfully imported my QSO database from DXLab on the old Win10 box. ?Fresh app talks to the rig and logs QSOs FB. I have populated

Try the following: Row 1 offset = 3 mm Row height = 37 mm Column 1 offset = 4 mm Column 2 offset = 72 mm Column 3 offset = 144 mm Label width = 64 mm You may need to tweak the column 2 and column 3

+ AA6YQ comments below + DXKeeper is not reducing the printable area to 288.961 X 203.2 mm - that printable area is what your printer driver is reporting. Three columns o

Hi, I am trying to print QSL labels on TOWER W100 labels on A4 sheets that are nominally 297 X 210 mm.? The labels are 37 X 70 mm in 3 columns and 8 rows.? The column offsets should be 0, 70, 140 as

Thanks Dave - new radio=lots of questions Norman [email protected]> wrote:

+ AA6YQ comments below + The appropriate article in "Getting Started with DXLab" is here: https://www.dxlabsuite.com/dxlabwiki/FlexSignature 73, Dave, AA6YQ

Hi Group, I finally bit the bullet and my new Flex 8400 should be here tomorrow. Is the documentation in TransceiverControlFlexradio - DX Lab Suite Wiki (