|
Dave, AA6YQ
This release
toggle quoted message
Show quoted text
- corrects the regression introduced in version 1.2.9, in which rotor control enable is not saved between DXView sessions - hides the rotor's Serial Port Interface panel if you select an ARSWIN controller (thanks, Pablo!) If you've already installed DXView, you can upgrade by downloading - store it in your DXView folder and execute it; you can then run the extracted DXView130.exe . Your online help will be updated by this process. 73, Dave, AA6YQ -----Original Message-----
From: Richard B Drake [mailto:rich@...] Sent: Sunday, April 22, 2001 11:55 AM To: Dxlab Subject: [dxlab] DXView V1.2.9 V1.2.9 disables rotor control when closed so that it has to be enabled each time it is brought up. ----- 73, Rich - W3ZJ www.w3zj.com Yahoo! Groups Sponsor To unsubscribe from this group, send an email to: dxlab-unsubscribe@... Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. |
